REPAIR INSTRUCTIONS, PART 1
Page 311
358
Figure 358 — Oil Pump Installation
After the oil pump has been installed, check the
backlash between the auxiliary shaft gear and the
oil pump driven gear.
3. Check the auxiliary shaft gear-to-oil pump
driven gear backlash, using a thickness
gauge inserted between the auxiliary shaft
gear and the oil pump driven gear. The
backlash should be within specification,
0.0072–0.0138 inch (0.1829–0.3505 mm)
Front Cover Installation
[211 RP]
With the crankshaft, camshaft and auxiliary shaft
in place, install the front cover.
1. Apply a light coat of RTV silicone to the
timing cover mounting surface.
2. Position the timing cover on the cylinder
block mounting surface.
3. Install the mounting capscrews in the timing
cover and tighten the capscrews to
specification, 40 lb-ft (55 N폷m), using torque
wrench J 24407, or equivalent.
4. Position the front pedestal mount on the
timing cover and install the mounting
capscrews. Tighten the pedestal mounting
capscrews to 70 lb-ft (95 N폷m), using torque
wrench J 24407, or equivalent.
1. Lubrication Oil Pump
2. Mounting Capscrews
3. Cylinder Block
5-111.bk Page 311 Monday, July 10, 2006 2:26 PM
To Next Page
Loading...
