REPAIR INSTRUCTIONS, PART 1
Page 181
180
Figure 180 — Carbon Removal from Cylinder Sleeves
4. Rotate the crankshaft so that pistons 1 and 6
are at bottom dead center. Remove the
connecting rod capscrews and the rod
bearing caps. Refer to Figure 181.
181
Figure 181 — Piston and Connecting Rod Assembly
Removal
5. Using a hammer handle, push piston 1 from
the cylinder bore. Remove piston 6 in the
same manner.
6. After removing pistons 1 and 6, rotate the
crankshaft so that the next set of pistons
(2 and 5) is at bottom dead center.
7. Repeat steps 2 through 6 to remove piston
sets 2 and 5, and 3 and 4.
5-111.bk Page 181 Monday, July 10, 2006 2:26 PM
To Next Page
Loading...
