Page 292
REPAIR INSTRUCTIONS, PART 1
7. If the clearance is not within specification,
correct the clearance as required. Be sure to
use the proper size bearing(s).
앫 If the clearance is less than specified,
check behind the bearing for dirt, chips
or burrs which would prevent the
bearing from seating properly.
앫 If the bearing bores and inserts are
clean and undamaged, replace the
inserts with inserts sized to provide the
specified clearance.
8. Reposition the cap on the journal. Lubricate
the capscrews with clean engine oil of the
proper specification. Lubricate and install the
bearing cap buttress capscrews as required,
finger-tight. Install the bearing cap
capscrews and tighten to the specified
torque value, 210 lb-ft (285 N폷m), using
torque wrench J 24407, or equivalent.
Refer to Figure 328.
There are two buttress capscrew dimensions:
앫 LH side 2, 3, 5, 6 and RH side 5 and 6
(6 total) are 80 mm long (1).
앫 RH side FRT 2 and 3 (2 total) are 110 mm
long (2).
328
Figure 328 — Buttress Capscrew Locations
1. 80 mm Buttress Capscrews 2. 110 mm Buttress Capscrews
5-111.bk Page 292 Monday, July 10, 2006 2:26 PM
To Next Page
Loading...
