Page 318
REPAIR INSTRUCTIONS, PART 1
367
Figure 367 — Cylinder Head Alignment
7. Using torque wrench J 24407, or equivalent,
tighten all cylinder head mounting
capscrews to specification in three steps as
listed below. Refer to Figure 368 for the
tightening sequence.
a. Tighten all capscrews in sequence to
50 lb-ft (68 N폷m).
b. Tighten all capscrews in sequence to
125 lb-ft (170 N폷m).
c. Tighten all capscrews in sequence to
the final specified torque value of
205 lb-ft (278 N폷m).
1. Cylinder Heads
2. Cylinder Block
3. Straightedge
5-111.bk Page 318 Monday, July 10, 2006 2:26 PM
To Next Page
Loading...
