Overview
4-12
4.1.7 cluster-cli
Priv Exec Command
Use this command to cluster all the CLI pertaining to the context it appears. This feature is useful to configure
each switch in the cluster by logging in to one participating switch. This eliminates administrator time and
effort, as one switch configuration can represent the entire cluster.
A new context called redundancy is available to support the cluster-cli. Any commands executed under this
context are also executed in each cluster member.
Syntax
cluster-cli enable
Parameters
Example
RFS7000(config)#show redundancy-members
Member ID : 192.168.100.1
Member State : Peer Seen
Member First Seen : Mar 15 16:24:54 2008
Member Last Seen : Mar 15 16:25:00 2008
Number of HB sent : 38044
Number of HB received : 3
Number of Update sent : 0
Number of Update received : 0
Member Standby Mode : Primary
Member AP adoption count : 0
Member Installed License Count: 0
Member Radio portal Count : 0
Member Associated MU Count : 0
Member Rogue AP detected Count: 0
Member Self Healing AP Count : 0
Member Switch Adopt Capacity : 0
Member Running Image Version :
RFS7000(config)#
RFS7000:cluster-cli#show version
*** START: Response from member: 172.20.15.18 ****
RFS7000 version 1.0.1.0-005D
Copyright (c) 2006-2007 Motorola, Inc.
Booted from primary.
Switch uptime is 7 days, 4 hours 28 minutes
*** END: Response from member: 172.20.15.18 ****
RFS7000 version 1.0.1.0-005D
Copyright (c) 2006-2007 Motorola, Inc.
Booted from primary.
Switch uptime is 7 days, 4 hours 28 minutes
RFS7000:cluster-cli#
enable Enables the cluster context.
To Next Page
Loading...
Need help?
General
