Global Configuration Commands
The term global is used to indicate characteristics or features effecting the system as a whole. Use the Global
configuration mode to configure the system globally, or enter specific configuration modes to configure
specific elements (such as interfaces or protocols). Use the configure terminal command, under PRIV EXEC, to
enter the global configuration mode.
The example below describes how to enter the global configuration mode from the privileged EXEC mode:
RFS7000# configure terminal
RFS7000(config)#
Commands entered in the global configuration mode update the running configuration file as soon as they are
entered. However, these changes are not saved in the startup configuration file until a copy running-config
startup-config EXEC mode command is issued.
NOTE The system prompt changes to indicate you are in global configuration mode. The
prompt for global configuration mode consists of the host-name of the device
followed by (config) and the pound sign (#).
To Next Page
Loading...
Need help?
General
