Motorola RFS7000 Series - Service

19-27
19.1.15 service
RADIUS Configuration Commands
Use this command to invoke service commands to trobuleshoot or debug (config-radsrv) instance
configurations. This command is also used to enable the RADIUS Server.
Syntax
service (show) (cli)
Parameters
Example
RFS7000(config-radsrv)#service show cli
Radius Configuration mode:
+-authentication
+-data-source
+-ldap [authentication data-source (local|ldap)]
+-local [authentication data-source (local|ldap)]
+-eap-auth-type
+-all [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-mschapv2|peap-
gtc|peap-mschapv2|tls|all)]
+-peap-gtc [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-
mschapv2|peap-gtc|peap-mschapv2|tls|all)]
+-peap-mschapv2 [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-
mschapv2|peap-gtc|peap-mschapv2|tls|all)]
+-tls [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-mschapv2|peap-
gtc|peap-mschapv2|tls|all)]
+-ttls-md5 [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-
mschapv2|peap-gtc|peap-mschapv2|tls|all)]
+-ttls-mschapv2 [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-
mschapv2|peap-gtc|peap-mschapv2|tls|all)]
+-ttls-pap [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-
mschapv2|peap-gtc|peap-mschapv2|tls|all)]
+-ca
+-trust-point
+-WORD [ca trust-point WORD]
+-clrscr [clrscr]
+-crl-check
+-enable [crl-check enable]
+-do
+-LINE [do LINE]
+-end [end]
+-exit [exit]
+-group
+-WORD [group WORD]
+-help [help]
+-ldap-server
+-primary
+-host
+-A.B.C.D
+-port
+-<1-65535>
+-login
+-WORD
+-bind-dn
.................................................................................
.................................................................................
RFS7000(config-radsrv)#
show (cli) Shows running system information.