Motorola RFS7000 Series - Terminal

Overview
14-22
14.1.11 terminal
Extended ACL Config Commands
Use this command to set the length/number of lines displayed on the terminal window.
Syntax
terminal(monitor|no)
terminal no(monitor)
Parameters
Usage Guidelines
By default, the log messages are generally not displayed over a telnet session. Use the terminal monitor
command to view the log messages over a telnet session.
Example
RFS7000(config-ext-nacl)#terminal monitor
RFS7000(config-ext-nacl)#
RFS7000(config-ext-nacl)#terminal no monitor
RFS7000(config-ext-nacl)#
monitor Copies debug output to the current terminal line.
no Negates a command or set its defaults.
• monitor – Copies debug output to the current terminal line.