Motorola RFS7000 Series - Configuring Interface Using MSTP

13-13
13.2 Configuring Interface using MSTP
MSTP is enabled by default. All VLANs are in the default instance 0 by default.
1. Use the following command to create a non-default instance and region configuration using the
mst
config
mode:
RFS7000(config-mst)#instance 1 vlan <vlan-id>
2. Use the following to enable/disable MSTP:
RFS7000(config)#bridge multiple-spanning-tree
3. Use the following command to configure spanning-tree:
RFS7000(config)#bridge multiple-spanning-tree
RFS7000(config)#spanning-tree
4. Use the following command to configure spanning-tree for ports:
RFS7000(config-if)#spanning-tree