Interface Instance
Use the (config-if) instance to configure Fast Ethernet (fe), Giga Ehternet (ge), StaticAggregate interface
(sa), VLAN and tunnel . Use the
(config)# interface [fe|ge|sa|tunnel|vlan] to reach this instance.
12.1 Interface Config commands
Table 12.1 summarizes the config-if commands.
Table 12.1 Interface Config Command Summary
Command Description Ref.
clrscr Clears the display screen. page 12-3
description Interface specific description. page 12-4
duplex Defines the duplex mode of operation. page 12-5
end Ends the current mode and moves to the EXEC mode. page 12-6
exit Ends the current mode and moves down to the previous mode. page 12-7
help Describes the interactive help system. page 12-8
ip Configures an IP address for the assigned Ethernet, VLAN or tunnel. page 12-9
mac MAC interface commands to configure MAC access list to a gigabit
ethernet interface.
page 12-11
management Sets the selected interface as the management interface. page 12-12
mtu Sets the mtu value for the VLAN interface. page 12-13
To Next Page
Loading...
