5-13
5.1.5 boot
Global Configuration Commands
This command reboots the switch with an image present in the mentioned partition (either the primary or
secondary partition).
Syntax
boot(system [primary|secondary])
Parameters
Example
RFS7000(config)#boot system primary
Wireless switch will be rebooted, do you want to continue? (y/n):y
Do you want to save the configuration? (y/n):y
The system is going down NOW !!
% Connection is closed by administrator!
Please stand by while rebooting the system.
system Specifies the boot image used after reboot.
primary Specifies the primary image.
secondary Specifies the secondary image.
To Next Page
Loading...
