20-45
20.1.32 sensor
Wireless Configuration Commands
Use this command to configure Wireless Intrusion Protection System (WIPS) parameters.
Syntax
sensor(<1-48>|default-config|ping-interval <2-60>|vlan)
sensor <1-48> [default-config|request-config|revert-to-ap]
sensor default-config(ip-mode|wips-server-ip)
sensor default-config ip-mode(dhcp|static(A.B.C.D/M)(A.B.C.D))
sensor default-config wips-server-ip(primary|secondary)(A.B.C.D)
Parameters
Example
RFS7000(config-wireless)#sensor vlan 268 500
RFS7000(config-wireless)#
<1-48> [default-
config|request-
config|revert-to-ap]
Select a sensor to reset/revert the AP to its original state. Use the
show
wireless sensor
command to view the sensor index.
• default-config – Restore the internal configuration of the sensor to
defaults.
• request-config – Poll the sensor for its latest configuration information.
• revert-to-ap – Revert an IDS sensor back to an access port that can service
mobile-units.
default-config
(ip-mode|wips-server-ip)
Default configuration sent to sensors when configured.
• ip-mode – Configures the IP address mode of the sensors.
• dhcp – Sensors must use DHCP to obtain an IP address.
• static (A.B.C.D/M)(A.B.C.D) – Sensors must use the specific static IP
address.
A.B.C.D/M – Sensor IP address and network mask.
A.B.C.D – Specifies the gateway IP address for sensors.
• wips-server-ip – Specifies the IP addresses of the WIPS server.
• primary (A.B.C.D) – Specifies the primary IP address of the WIPS
Server.
• secondary (A.B.C.D) – Specifies the secondary IP address of the WIPS
Server.
ping-interval <2-60>
Sets the ping interval (in seconds) between successive pings to sensors on the
network.
vlan<1-4094>
Configures VLANs where sensors are to be discovered.
To Next Page
Loading...
