Overview
20-34
20.1.28 qos-mapping
Wireless Configuration Commands
Use this command to configure QoS mappings between wired and wireless domains.
Syntax
qos-mapping(wired-to-wireless|wireless-to-wired)
qos-mapping wired-to-wireless(dot1p<0-7>|dscp<0-63>)
(background|best-effort|video|voice)
qos-mapping wireless-to-wired(background|best-effort|video|voice)
dot1p<0-7>
Parameters
Example
RFS7000(config-wireless)#qos-mapping wireless-to-wired background dot1p 5
RFS7000(config-wireless)#
wired-to-wireless Mappings used while switching wired traffic over the air.
• dot1p<0-7> – Configures the mapping of 802.1p tags to access
categories. Specify more than one 802.1p tag (0-7) if needed.
• dscp<0-63> – Configures the mapping of DSCP values to access
categories. Specify more than one DSCP value (0-63) if needed.
• background – Background category traffic.
• best-effort – Best effort category traffic.
•video – Video traffic category traffic.
•voice – Voice traffic category traffic.
wireless-to-wired Mappings used while switching wireless traffic to rest of the network.
• dot1p<0-7> – Configures 802.1p tags that correspond to selected access
categories.
To Next Page
Loading...
