Overview
20-8
20.1.5 ap-detection
Wireless Configuration Commands
Use this command to configure access port detection.
Syntax
ap-detection
[approved|enable|mu-assisted-scan|timeout (approved|unapproved)]
ap-detection approved add <1-200> (MAC Address)(SSID)
ap-detection mu-assisted-scan(enable|refresh<30-86400>)
Parameters
Example
RFS7000(config-wireless)#ap-detection enable
RFS7000(config-wireless)#
RFS7000(config-wireless)#ap-detection approved add 150 any any
RFS7000(config-wireless)#
RFS7000(config-wireless)#ap-detection mu-assisted-scan enable
RFS7000(config-wireless)#
RFS7000(config-wireless)#ap-detection mu-assisted-scan refresh 520
RFS7000(config-wireless)#
RFS7000(config-wireless)#ap-detection timeout approved 500
RFS7000(config-wireless)#
approved The approved access port list.
• add <1-200> – Adds an entry to the approved access port list.
• MAC Address – Select either:
• MAC– MAC address in AA-BB-CC-DD-EE-FF format.
• any– Any MAC address.
• SSID – Select either:
• LINE–A string of up to 32 characters.
• any– Any SSID.
enable Allows access ports to look for access points.
mu-assisted-scan Mobile unit assisted scanning.
• enable – Enables mobile unit assisted scanning.
• refresh<30-86400> – The period (in seconds) used by all scan-capable
mobile units are polled to scan for neighboring access port’s.
timeout <1-65535> The interval (in seconds) an access port remains in the list after it is no longer
seen. Select one of the following options for timeout implementation.
• approved
• unapproved
To Next Page
Loading...
