Motorola RFS7000 Series - Service

Overview
12-16
12.1.13 service
Interface Config commands
Use this command to invoke service commands to trobuleshoot or debug the (config-if) instance
configurations.
Syntax
service(show) (cli)
Parameters
Example
RFS7000(config-if)#service show cli
Interface Config mode:
+-cisco-interoperability
+-disable [cisco-interoperability ( enable | disable)]
+-enable [cisco-interoperability ( enable | disable)]
+-clrscr [clrscr]
+-description
+-LINE [description LINE]
+-do
+-LINE [do LINE]
+-duplex
+-auto [duplex (half|full|auto)]
+-full [duplex (half|full|auto)]
+-half [duplex (half|full|auto)]
+-end [end]
+-exit [exit]
+-help [help]
+-ip
+-access-group
+-<1-99>
+-in [ip access-group (<1-99>|<100-199>|<1300-1999>|<2000-2699>|WORD) (in)]
+-<100-199>
+-in [ip access-group (<1-99>|<100-199>|<1300-1999>|<2000-2699>|WORD) (in)]
+-<1300-1999>
+-in [ip access-group (<1-99>|<100-199>|<1300-1999>|<2000-2699>|WORD) (in)]
+-<2000-2699>
+-in [ip access-group (<1-99>|<100-199>|<1300-1999>|<2000-2699>|WORD) (in)]
+-WORD
+-in [ip access-group (<1-99>|<100-199>|<1300-1999>|<2000-2699>|WORD)
(in)]............................................................................
.................................................................................
.................................................................................
.................................................................................
..............................................
RFS7000(config-if)#
show Shows running system information.
cli Shows the CLI tree of current mode.