5-69
5.1.33 username
Global Configuration Commands
Use this CLI command to establish the user name authentication.
Syntax
username <name> (access|password|privilege)
username <name> access (console|ssh|telnet|web)
username <name> password(0|1|Line)
username <name> privilege(helpdesk|monitor|nwadmin|superuser|sysadmin|webadmin)
Parameters
Example
RFS7000(config)#username GoldenSwitch
RFS7000(config)#
name Enter a name to authenticate the switch. The username must be between 1 - 28
characters.
access Sets the user access mode.
• console – Only allowed from console.
• ssh – Only allowed from ssh.
• telnet – Only allowed from telnet.
• web – Only allowed from applet (webUI).
password Specifies the user password.
• 0– Password is specified UNENCRYPTED.
• 1– Password is encrypted with SHA1 algorithm.
• LINE– User password (plaintext passsword length must be between 8
and 32 characters).
privilege Sets user access privileges.
• helpdesk – Helpdesk (troubleshooting) access.
• monitor – Monitor (read-only) access.
• nwadmin – Network (wired & wireless) admin access.
• superuser – Superuser (root) access.
• sysadmin – System (general system configuration) admin access.
• webadmin – Web auth (hotspot) user admin access.
To Next Page
Loading...
