Overview
12-12
12.1.9 management
Interface Config commands
Use this command to configure the selected interface as the management interface. It can only be used on a
VLANx interface. The tftp/ftp server, which provides the switch its config file at startup, must be accessible
via this interface.
VLAN 1 is by default the management interface for the RFS7000 switch.
Syntax
management
Parameters
None.
Usage Guidelines
Management privilage can be set only on a L3 interface. Use this command along with the (config)
management secure in config mode. This ensures switch management access is restricted to the
management VLAN only.
Refer management on page 5-39 for
(config) management secure configuration.
Example
RFS7000(config)#interface vlan 1000
RFS7000(config-if)#management
RFS7000(config-if)#
To Next Page
Loading...
