Motorola RFS7000 Series - Terminal

Overview
15-14
15.1.11 terminal
Standard ACL Config Commands
Use this command to set the length /number of lines displayed on the terminal.
Syntax
terminal(monitor|no)
terminal no(monitor)
Parameters
Usage Guidelines
By default, log messages are not displayed over a Telnet session. Use the terminal monitor command to
view the log messages over a Telnet session.
Example
RFS7000(config-std-nacl)#terminal monitor
RFS7000(config-std-nacl)#
RFS7000(config-std-nacl)#terminal no monitor
RFS7000(config-std-nacl)#
monitor Copies debug output to the current terminal line.
no Negates a command or set its defaults.
• monitor – Copies debug output to the current terminal line.