Motorola RFS7000 Series - Chapter 9. Crypto - Ipsec Instance; Crypto Ipsec Config Commands

Crypto - ipsec Instance
Use the (config-crypto ipsec) instance to define the transform configuration for securing data(e.g., esp-
3des, esp-sha-hmac, etc.). The transform-set is then assigned to a crypto map using the map’s set transform-
set command. For more details see crypto-map transform-set on page 10-9.
9.1 Crypto IPsec Config Commands
Table summarizes the config-crypto-ipsec commands within the RFS7000 Switch command line interface.
Table 9.1 Crypto IPSec Command Summary
Command Description Ref.
clrscr
Clears the display screen.
page 6-2
end
Ends the current mode and moves to the EXEC mode.
page 6-3
exit
Ends the current mode and moves to the previous mode.
page 6-4
help
Displays the interactive help system.
page 6-5
mode
Configures IPSec Transporation Mode.
page 9-2
no
Negates a command or set its defaults.
page 6-6
service
Displays service commands.
page 6-7
show
Show running system information.
page 9-3