Motorola RFS7000 Series - Chapter 21. SOLE Instance; Adapter

Overview
21-2
21.1.1 adapter
SOLE Config Commands
Use this command to enable or disable SOLE adapter.
Syntax
adapter (aeroscout) (enable)
Parameters
Usage Guidelines
Use [no] adapter [aeroscout(enable)|enable] to disable aeroscout or all SOLE adapter. The SOLE
adapter is
disabled by default.
Example
RFS7000(config-sole)#adapter aeroscout enable
RFS7000(config-sole)#
adapter
(aeroscout) (enable)
SOLE Adapter name.
• aeroscout – Name of the adapter.
• enable – Enables SOLE adapter.
NOTE SOLE currently supports only Aeroscout adapter.