14-19
14.1.9 service
Extended ACL Config Commands
Use this command to invoke service commands to troubleshoot or debug (config-if) instance
configurations.
Syntax
service(clear|diag-shell|save-cli|show|start-shell)
Parameters
Example
RFS7000(config-ext-nacl)#service diag-shell
Diagnostic shell started for testing
diag >
boot Reboots the switch
delete Deletes specified file from the system.
exit Exit from the CLI
fallback Configures firmware fallback feature
help Description of the interactive help system
logout Exit from the CLI
no Negate a command or set its defaults
reload Halt and perform a warm reboot
service Service Commands
show Show running system information
upgrade Upgrade firmware image
RFS7000(config-ext-nacl)#service save-cli
CLI command tree is saved as clitree.html.
This tree can be viewed via web at http://<ipaddr>/cli/clitree.html
RFS7000(config-ext-nacl)#
RFS7000(config-ext-nacl)#service show ?
cli Show CLI tree of current mode
command-history Display command (except show commands) history.
crash-info Display information about core, panic and AP dump files
info Show snapshot of available support information
last-passwd Display last password used to enter shell
reboot-history Show reboot history
startup-log Show startup log
upgrade-history Show upgrade history
RFS7000(config-ext-nacl)#service show
RFS7000(config-ext-nacl)#service start-shell
Last password used: password with MAC 00:a0:f8:65:ea:8e
Password:
clear Removes specified support information.
diag-shell Provides diagnostic shell access to debug and test the RFS7000 Switch.
save-cli Saves the CLI tree for all modes in html format.
show Shows running system information.
start-shell Provides shell access.
To Next Page
Loading...
Need help?
General
