Motorola RFS7000 Series - Service

Overview
11-32
11.1.12 service
Trustpoint Config commands
Use this command to invoke service commands to trobuleshoot or debug crypto pki trustpoint instance
configurations.
Syntax
service(show)(cli)
Parameters
Example
RFS7000(config-trustpoint)#service show cli
Trustpoint Config mode:
+-clrscr [clrscr]
+-company-name
+-WORD [company-name WORD]
+-do
+-LINE [do LINE]
+-email
+-WORD [email WORD]
+-end [end]
+-exit [exit]
+-fqdn
+-WORD [fqdn WORD]
+-help [help]
+-ip-address
+-A.B.C.D [ip-address A.B.C.D]
+-no
+-company-name [no company-name]
+-email [no email]
+-fqdn [no fqdn]
+-ip-address [no ip-address]
+-subject-name [no subject-name]
+-password
+-0
+-WORD [password (0|2|) WORD]
+-2
+-WORD [password (0|2|) WORD]
+-WORD [password (0|2|) WORD]
+-quit [quit]
+-rsakey
+-WORD [rsakey WORD]
+-rsakeypair
+-WORD [rsakeypair WORD]
+-s
+-commands [show commands]
+-WORD [show commands WORD]
+-running-config [show running-config]
+-full [show running-config full]
+-include-factory [show running-config include-factory]
+-service
+-show
.................................................................................
.................................................................................
.................................................................................
.................................................................................
....
RFS7000(config-trustpoint)#
show (cli) Shows the CLI tree of current mode.