2-67
2.2.27 spanning-tree
Common to all modes
Syntax
show spanning-tree mst
[config|detail (interface){<IF Name>|fe|ge <1-4>|sa <1-4>|tunnel <1-32> |vlan <1-
4094>}|instance <1-15>(interface){<IF Name>|fe|ge <1-4>|sa <1-4>|tunnel <1-32>
|vlan <1-4094>}]
Parameters
Example
RFS7000>show spanning-tree mst config
%
% MSTP Configuration Information for bridge 1 :
%------------------------------------------------------
% Format Id : 0
% Name : My Name
% Revision Level : 0
% Digest : 0xAC36177F50283CD4B83821D8AB26DE62
%------------------------------------------------------
RFS7000>
RFS7000>show spanning-tree mst detail interface ge 1
% Bridge up - Spanning Tree Enabled
% CIST Root Path Cost 0 - CIST Root Port 0 - CIST Bridge Priority 32768
% Forward Delay 15 - Hello Time 2 - Max Age 20 - Max-hops 20
% 1: CIST Root Id 800000157037fbef
% 1: CIST Reg Root Id 800000157037fbef
% 1: CST Bridge Id 800000157037fbef
% portfast bpdu-filter enabled
% portfast bpdu-guard disabled
% portfast errdisable timeout disabled
% portfast errdisable timeout interval 300 sec
% cisco interoperability not configured - Current cisco interoperability off
% ge1: Port 2001 - Id 87d1 - Role Designated - State Forwarding
% ge1: Designated External Path Cost 0 -Internal Path Cost 0
config Displays MSTP configuration information.
detail (interface)
{<IF Name>|fe|ge <1-4>|
sa <1-4>|tunnel <1-32> |
vlan <1-4094>}
Displays detailed interface information.
• IF Name – Interface name.
• fe – FastEthernet interface.
• ge <1-4> – GigabitEthernet interface.
• sa <1-4> – StaticAggregate interface.
• tunnel <1-32> – Tunnel interface.
• vlan <1-4094> – VLAN interface.
instance (interface <1-
15>)
{<IF Name>|fe|ge <1-4>|
sa <1-4>|tunnel <1-32> |
vlan <1-4094>}
Displays instance information.
• IF Name – Interface name.
• fe – FastEthernet interface.
• ge <1-4> – GigabitEthernet interface.
• sa <1-4> – StaticAggregate interface.
• tunnel <1-32> – Tunnel interface.
• vlan <1-4094> – VLAN interface.
To Next Page
Loading...
Need help?
General
