Wireless Instance
Use the (config-wireless)instance to configure wireless parameters.
20.1 Wireless Configuration Commands
Table 20.1 summarizes the Global Config commands.
Table 20.1 Wireless Configuration Command Summary
Command Description Ref.
aap Envokes AAP commands to define how the switch passes adaptive AP
configurations to adopted APs.
page 20-4
adopt-unconf-
radio
Adopts a radio even if not configured. The default templates is used for
configuration.
page 20-5
adoption-pref-id Defines a preference identifier for the switch. All radios configured with
this identifier are more likely to be adopted by this switch.
page 20-6
ap Envokes AP related commands to define the name and location of the AP. page 20-7
ap-detection Access port detection configuration commands. page 20-8
ap-ip Modifies static IP information for access ports. page 20-9