Overview
20-28
20.1.22 mobile-unit
Wireless Configuration Commands
Use this command to configure mobile unit related parameters.
Syntax
mobile-unit (association-history(enable)|probe-history)
mobile-unit probe-history (add<1-200> <MAC Address>|enable)
Parameters
Example
RFS7000(config-wireless)#mobile-unit probe-history enable
RFS7000(config-wireless)#
RFS7000(config-wireless)#mobile-unit association-history enable
RFS7000(config-wireless)#
RFS7000(config-wireless)#mobile-unit probe-history add 20 AA-BB-CC-DD-EE-FF
RFS7000(config-wireless)#
association-history Enables the mobile unit’s association history.
• enable – Enables the mobile unit’s association history.
probe-history Mobile unit probe logging configuration commands.
• add <1-200> – Adds a mobile unit to probe history logging. Select an
index value between 1 to 200 to add probe logging MAC.
• MAC Address – The MAC address of the mobile used for probe history
logging.
enable Enables mobile unit probe logging.
To Next Page
Loading...
