Motorola RFS7000 Series - Self-Heal

20-43
20.1.31 self-heal
Wireless Configuration Commands
Use this command to configure self healing.
Syntax
self-heal(interference-avoidance|neighbor-recovery)
self-heal interference-avoidance(enable|hold-time<0-65535>|
retries<0.0-15.0>)
self-heal neighbor-recovery(action|enable|neighbors|run-neighbor-detect)
self-heal neighbor-recovery action(both|none|open-rates|raise-power)
radio(<1-4096>|RADIO)
self-heal neighbor-recovery neighbors<1-1000>(<1-1000>|RADIO)
Parameters
interference-avoidance
Interference avoidance configuration.
enable
Enables/disables interference avoidance.
hold-time<0-65535>
The interval (in seconds) to disable interference avoidance after a detection . This
prevents a radio from changing channels continuously. Set the hold-time
between 0-65535 seconds.
retries<0.0-15.0>
The average number retries to force a radio to re-run auto channel selection. Set
a value between 0-15.
neighbor-recovery
Neighbor recovery configuration commands.
action
(both|none|open-rates|
raise-power)
radio (<1- 4096>|RADIO)
Radio self healing action when neighbors are detected down.
• both – Raises the power to max and open all rates.
• none – Does nothing.
• open-rates – Opens all rates.
• raise-power – Raises the power to max.
• radio – Modifies the action for specified radio(s).
• <1-4096> – A single radio index.
• RADIO – A list (1,3,7) or range (3-7) of radio indices.
enable
Monitors access ports and attempts to increase coverage on failure.
neighbors<1-1000>
(<1- 4096>|RADIO)
Adds radios as neighbors.
run-neighbor-detect
Disassociates mobile units, clears current neighbors and runs neighbor
detection.