Standard ACL Instance
Use the (config-std-nacl) instance to configure ip access-list standard ACLs. Standard ACLs
allow filtering based on the source address only.
15.1 Standard ACL Config Commands
Table 15.1 summarizes config-std-nacl commands.
Table 15.1 Standard ACL Config Command Summary
Command Description Ref.
clrscr Clears the display screen. page 15-3
deny Specifies packets to reject. page 15-4
end Ends the current mode and changes to EXEC mode. page 15-5
exit Ends the current mode and moves to the previous mode. page 15-6
help Displays the interactive help system. page 15-7
mark Specifies packets to mark. page 15-8
no Negates a command or set its defaults. page 15-9
permit Specifies packets to forward. page 15-10
service Displays service commands. page 15-11
show Shows the running system information. page 15-12
To Next Page
Loading...
