Crypto - peer Instance
Use crypto isakmp(peer)[IP Address|dns|hostname] to initiates config-crypto-peer instance.
8.1 Crypto Peer Config Commands
Table 8.1 summarizes the config-crypto-peer commands within the RFS7000 switch command line
interface.
Table 8.1 Crypto Peer Command Summary
Command Description Ref.
clrscr
Clears the display screen.
page 8-2
end
Ends the current mode and moves to EXEC mode.
page 8-3
exit
Ends the current mode and moves to the previous mode.
page 8-4
help
Displays the interactive help system.
page 8-5
no
Negates a command or set its defaults.
page 8-6
service
Displays service commands.
page 8-7
set
Sets the configuration.
page 8-8
show
Shows running system information.
page 8-9
To Next Page
Loading...
