Motorola RFS7000 Series - Page 352

Overview
12-14
12.1.11 no
Interface Config commands
Use this command to negate a command or set defaults.
Syntax
no [description|duplex|ip|mtu|shutdown|
spanning-tree|speed|static-channel-group|switchport|tunnel]
Parameters
The no command negates any command associated with it. Wherever required, use the same parameters
associated with the command getting negated.
Example
RFS7000(config-if)#no mtu
RFS7000(config-if)#
RFS7000(config-if)#no spanning-tree link-type
RFS7000(config-if)#
RFS7000(config-if)#no spanning-tree portfast
RFS7000(config-if)#
RFS7000(config-if)#no spanning-tree portfast bpdu-guard
RFS7000(config-if)#
RFS7000(config-if)#no spanning-tree portfast bpdu-filter
RFS7000(config-if)#