Spanning Tree-MST Instance
Use the (config-mst) instance to configure the Multi Spanning Tree Protocol (MSTP). Use
(config)#spanning-tree mst configuration to reach this instance.
13.1 mst Config commands
Table 13.1 summarizes the config-mst commands.
Table 13.1 MSTP Config Command Summary
Command Description Ref.
clrscr Clears the display screen. page 13-2
end Ends the current mode and moves to the EXEC mode. page 13-3
exit Ends the current mode and moves to the previous mode. page 13-4
help Describes the interactive help system. page 13-5
instance Assigns a VLAN to the bridge instance. page 13-6
name Sets a name for the MST region. page 13-7
no Negates a command or sets defaults. page 13-8
revision Configures the revision number of the MST bridge. page 13-9
service Displays service commands. page 13-10
show Shows running system information. page 13-11
To Next Page
Loading...
