2-45
RFS7000#show ip dhcp pool
!
ip dhcp pool pl
!
ip dhcp pool pool1
domain-name test.com
bootfile 123
network 10.10.10.0/24
address range 10.10.10.2 10.10.10.30
!
ip dhcp pool poo110
next-server 1.1.1.1
netbios-node-type b-node
RFS7000#show ip dhcp-vendor-options
Server Info:
Firmware Image File:
Config File:
Cluster Config File:
RFS7000#show ip domain-name
IP domain-lookup : Enable
Domain Name : symbol.com
RFS7000#show ip http server
HTTP server: Running
Config status: Enabled
RFS7000#show ip http secure-server
HTTP secure server: Running
Config status: Enabled
Trustpoint: default-trustpoint
RFS7000#show ip interface brief
Interface IP-Address Status Protocol
vlan1 157.235.208.233(DHCP) up up
tunnel1 unassigned up up
RFS7000#show ip interface tunnel 1 ?
brief Brief summary of IP status and configuration
RFS7000#show ip interface tunnel 1 brief
Interface IP-Address Status Protocol
tunnel1 unassigned up up
RFS7000#show ip interface vlan 1 brief
Interface IP-Address Status Protocol
vlan1 157.235.208.233(DHCP) up up
RFS7000#show ip name-server
157.235.3.195 dynamic
157.235.3.196 dynamic
RFS7000(config)#show ip nat interfaces
=======================
Interface Direction
=======================
vlan1 UNKNOWN
vlan400 UNKNOWN
RFS7000(config)#
RFS7000(config)#show ip nat translations outside source
S/D Dir Actual Address NATed Address ACL Overload-If
RFS7000(config)#
RFS7000#show ip routing
IP routing is on
RFS7000(config)#show ip route detail
Codes: K - kernel/icmp, C - connected, S - static, D - DHCP
> - Active route, - Next-hop in FIB, p - stale info
S 1.1.0.0/16 [1/0] via 1.1.1.1 inactive
To Next Page
Loading...
