5 - 182 WiNG 5.6 Access Point System Reference Guide
Figure 5-120 Advanced Profile Configuration - Client Load Balancing screen
2. Use the Group ID field to define a group ID of up to 32 characters.
3. Use the drop-down menu to define a SBC strategy. Options include Prefer 5GHz, Prefer 2.4 GHz, and distribute-by-ratio.
The default value is Prefer 5GHz.
4. Set the following Neighbor Selection Strategies:
5. Select the Balance Band Loads by Ratio radio button to balance the radio load, by assigning a ratio to both the 2.4 and
5GHz bands. Balancing radio load by band ratio allows an administrator to assign a greater weight to radio traffic on either
the 2.4 or 5.0 GHz band. This setting is enabled by default.
Use probes from common
clients
Select this option to use probes from shared clients in the neighbor selection process.
This feature is enabled by default, to provide the best common group of available
clients amongst access points in neighbor selection.
Use notifications from
roamed clients
Select this option to use roamed client notifications in the neighbor selection process.
This feature is enabled by default, allowing access points in the neighbor selection
process to consider device roaming counts as selection criteria.
Use smart-rf neighbor
detection
Select this option to use SMART RF access point transmission adjustments as criteria
in the neighbor selection process. This feature is enabled by default.
To Next Page
Loading...
