11 - 4 WiNG 5.6 Access Point System Reference Guide
8. Select Clear All to clear the events displayed on this screen and begin a new event data collection.
9. Select Event History from the upper, left-hand, side of the Fault Management browser.
The Event History screen displays events for both wireless controllers and access points. The Controller(s) tab displays by
default. Information on this tab can be filtered by controllers and then further by the RF Domains on the selected controller.
Similarly, the Access Point(s) tab displays information for each RF Domain on the access point and this information can be
further filtered on the devices adopted by this access point.
Figure 11-3 Fault Management - Event History screen
10. In the Controller(s) tab, select the controller from the Select a Controller field to filter events to display. To filter messages
further, select a RF Domain from the Filter by RF Domain field.
11. In the Access Point(s) tab, select the RF Domain from the Select a RF Domain field to filter events to display. To filter
messages further, select a device from the Filter by Device field.,
Module Displays the module used to track the event. Events detected by other modules are not
tracked.
Message Displays error or status messages for each event listed.
Severity Displays the severity of the event as defined for tracking from the Configuration screen.
Severity options include:
• All Severities – All events are displayed regardless of their severity
• Critical – Only critical events are displayed
• Error – Only errors are displayed
• Warning – Only warnings are displayed
• Informational – Only informational events are displayed
Source Displays the MAC address of the source device tracked by the selected module.
Hostname Displays the Hostname/IP address of the source device tracked by the selected module.
To Next Page
Loading...
