Electra Elite Issue 6
Features and Specifications Manual C - 39
.
1. Lift the handset or press
P
.
2. Dial the Call Forward - All Split Cancel Access Code (Default not
assigned).
3. Press
B
for Centrex
.
4. Dial the CAR key extension number.
5. Go on-hook or press
P
.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-1-46~48 [Access Code (1-, 2-, or 3--Digit)
Assignment] to assign Access Code for Call Forward - Split.
Use Memory Block 1-8-07 [Class of Service (Attendant) Feature
Selection 1] Page 2 LK 2 to Allow (default: LED On) or Deny (LED
Off) Call Forward Set/Cancel from destination.
Use Memory Block 1-8-07 [Class of Service (Attendant) Feature
Selection 1] Page 2 LK 3 to Allow (default: LED On) or Deny (LED
Off) System-wide reset of Call Forwarding.
Use Memory Block 3-91 (Trunk Type selection) to assign lines as
PBX (or CTX) or CTX (Assume 9).
Restrictions:
Memory Block 3-91 must have at least one trunk assigned as PBX
(or CTX) or CTX (Assume 9). When at least one trunk is not
assigned as PBX/CTX, the CTX/PBX=2 option is not displayed.
Call Forward - Centrex is not supported for Call Forward - All Call by
the Feature + 60 operation from destination.
Call Forward - Centrex is not supported for Single On/Off toggle key
operation.
A maximum of 16 digits can be stored as the destination outside
number.
Least Cost Routing cannot route the Call Forward destination
number.
When a Multiline Terminal with Call Forward - Centrex set has an
unplugged extension, the call is not forwarded.
To cancel Call Forward - All Split for Centrex from destination for
CAR key:
To Next Page
Loading...