C - 84 Cordless Telephone Connection
Issue 6 Electra Elite
1. Multiline Terminal user goes off-hook.
2. Single Line Telephone user goes on-hook (at this time, the call is
automatically connected to the Multiline Terminal).
1. Single Line Telephone user goes off-hook (at this time, the call is
automatically connected to the Single Line Telephone).
2. Multiline Terminal user goes on-hook.
Refer to operation for Single Line Telephone Access.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 4-39 (APR Ring Mode Assignment) to specify
NON (no Ring), STA (ring Station Number only, default), or ALL (ring
all stations) for SLTs connected to the APR/APA-U Unit for the
cordless telephone.
Use Memory Block 4-59 (APR/APA Hookflash Selection) to allow or
deny Hookflash on an APR/APA-U Unit. System Software S5500
or higher is required.
Restrictions:
A voice announced internal call to the Multiline Terminal does not
ring the cordless telephone.
The ADA(2)-W(BK)/(SW) Unit cannot be used in conjunction with an
ADA(1)-W(BK)/(SW) Unit.
Only one cordless Single Line Telephone can be connected to an
ADA(2)-W(BK)/(SW) Unit or APR/APA-U Unit.
When CO Prime Line is assigned to the associated Multiline
Terminal, internal dial tone cannot be transferred to the cordless
telephone.
To transfer a call from a cordless Single Line Telephone to its
associated Multiline Terminal:
To transfer a call from a Multiline Terminal to its associated
cordless Single Line Telephone:
To use APR/APA Hookflash:
To Next Page
Loading...