Electra Elite Issue 6
Features and Specifications Manual C - 85
The cordless telephone requires a PBR circuit while dialing. When
all PBR circuits are busy, a busy tone is heard when the phone goes
off-hook.
General:
This feature works with 2500 cordless Single Line Telephones.
Disconnect signal, DTMF sending (to cordless telephone), Message
Wait, transferring calls, placing calls on hold, hookswitch signals, and
DP cordless telephones are not supported for cordless telephones.
A maximum of 120 ADA(2)-W(BK)/(SW) Units or APR/APA-U Units
can be installed in Multiline Terminals on the Electra Elite 192
system. The maximum for the Electra Elite 48 system is 32.
The Multiline Terminal user and the associated cordless telephone
user cannot talk to each other.
An APR/APA-U Unit with hookflash enabled follows the same
operating procedures as a Single Line Terminal connected to an
SLI(8)-U10 ETU.
The Multiline Terminal LCD displays normal information for Multiline
Terminal when a cordless terminal is used.
When the Multiline Terminal user goes off-hook before the cordless
Single Line Telephone user, a PBR circuit is not connected for the
cordless Single Line Telephone.
The ring pattern for the cordless telephone can be selected by a
jumper switch in the ADA(2)-W(BK)/(SW) Unit. The patterns are:
• 1 second ON/2 seconds OFF
• 2 seconds ON/4 seconds OFF
The cordless telephone must be installed within 10 feet of the
ADA(2)-W(BK)/(SW) Unit or APR-U Unit.
RELATED FEATURES
LIST
Feature
Number
Feature Name
A-7 Ancillary Device Connection
D-21 Dterm® Cordless Terminal
C-23 Cordless Telephone Connection
To Next Page
Loading...