Electra Elite Issue 6
Features and Specifications Manual D - 87
1. Press Trf.
2. An Internal Dial tone is generated.
3. To return to the held party press the flashing green line key.
Note: After a programmed time the held call recalls to the originating terminal.
1. With a call in progress, press
R
on the Base unit.
2. Dial another station number.
3. Announce Conference (Optional).
4. Press
R
on the Base unit to establish the conference.
1. Slide the battery compartment cover on the lower Handset back
down to remove it.
2. Remove the IMPORTANT charging NOTE from the battery
compartment.
3. Align the guides on the bottom of the battery plug and insert it in
the connector.
4. Put the battery in the compartment with the description visible.
5. Replace and push up the cover to snap it in place.
Note:Ensure that the wires are inside the cover.
1. Position clip to the back side of the Handset unit with the clip
spring pointed up.
2. Align the four prongs of the clip to the four slots on the sides of
the Handset.
3. Gently press belt clip to snap the prongs into place.
To Hold a call in progress at the handset:
To establish a conference call at the base unit:
To Install the battery:
To install the belt clip:
To Next Page
Loading...