Electa Elite Issue 6
Features and Specifications Manual I - 19
Data Assignment for CO Line Services:
Use Memory Block 3-52 (ISDN Trunk Directory Number Assignment)
to assign the ISDN Directory Number.
Use Memory Block 3-91 (Trunk Type Selection) to specify each
ISDN-PRI trunk as CO Lines.
Use Memory Block 4-12 (Line Key Selection for Telephone Mode) to
assign the Trunk Appearance, Route Advance Block or CAP key to
line keys for D
term
Station using ISDN-PRI.
Use Memory Block 4-01 [CO/PBX Ringing Assignment (Day Mode)]
to assign ISDN-PRI trunks to ring during day mode at specified
stations.
Use Memory Block 4-02 [CO/PBX Ringing Assignment (Night Mode)]
to assign ISDN-PRI trunks to ring during night mode at specified
stations.
Use Memory Block 1-1-81 (ISDN Dial Interval Time Selection) to
specify the time (default: 4s) between dialed digits.
Data Assignment for DID Line Services:
Use Memory Block 3-91 (Trunk Type Selection) to specify each
ISDN-PRI trunk as DID Lines.
Note:Refer to D-9 Direct Inward Dialing in the Features and Specifications
Manual to convert incoming digits to the correct Station number.
Data Assignment for Call by Call:
Use Memory Block 1-13-03 (Call by Call Service Selection) to
specify whether YS or NO (default) Call by Call service is activated
per PRT.
Use Memory Block 1-10-00 (Call by Call Type of Network ID
Assignment) to assign the Network ID.
Use Memory Block 1-10-01 (Call by Call ID Plan Assignment) to
assign the Numbering Plan Identifier (default: 1).
Use Memory Block 1-10-02 (Call by Call Type of Number
Assignment) to assign the type of number (default: 0).
Use Memory Block 1-10-03 (Call by Call Numbering Plan ID
Assignment) to assign the Numbering Plan ID (default: 00).
Use Memory Block 1-10-04 (Call by Call Network ID Assignment) to
assign the Network ID (default: Not Specified).
To Next Page
Loading...