I - 20 ISDN-PRI Trunk Connections
Issue 6 Electra Elite
Use Memory Block 1-10-05 [Call by Call Facility Coding Value
Assignment (Service)] to assign the Service Facility Coding Value
(default: 00).
Use Memory Block 1-10-06 [Call by Call Facility Coding Value
Assignment (Feature)] to assign the Feature Facility Coding Value
(default: 00).
Use Memory Block 1-10-07 (Call by Call Service Parameter
Assignment) to assign the Service Parameter (default: 0-000).
Use Memory Block 1-10-08 (Call by Call Max Digit Assignment) to
assign the maximum digit (default: 00, no limit).
Use Memory Block 1-10-09 (Call by Call Simulated Facility Group
Assignment) to assign the simulated facility group (default: 00).
Use Memory Block 1-10-20 (Call by Call Outgoing SFG Assignment)
to assign Outgoing SFG (default: 99).
Use Memory Block 1-10-21 (Call by Call Outgoing/Incoming SFG
Assignment) to assign Outgoing/Incoming SFG (default: 99).
Use Memory Block 1-10-22 (Call by Call Incoming Type Selection) to
assign incoming type (default: DID).
Data Assignments for Caller ID Calling Party Number (CPN)
Use Memory Block 1-8-08 [Class of Service (Station) Feature
Selection 2] Page 4 LK3 to allow (LED ON) or deny (default: LED
Off) Caller ID.
Use Memory Block 1-8-08 [Class of Service (Station) Feature
Selection 2] Page 4 LK4 to allow (LED ON) Caller ID Number display
or deny (default: LED Off) to display the Caller ID Name when Name
and Number are received.
Use Memory Block 1-8-08 [Class of Service (Station) Feature
Selection 2] Page 5 LK7 to allow (LED ON) or deny (default: LED
Off) display of both name and number. Page 4 LK4 selects the
position of the name or number on the display for the stations
assigned to the Class of service. System Software S4000 or higher
is required to provide both name and number at the same time.
PRT(1)-10/20 Firmware Version 3.50 or higher is required to support
name delivery on ISDN-PRI. Both the name and number must be
received in a supported format. Refer to the Supported Protocols
and Name Delivery Formats Table.
Use Memory Block 4-17 (Station to Class of Service Feature
Assignment) to assign each station to Class of Service Assignments.
To Next Page
Loading...