Electra Elite Issue 6
Features and Specifications Manual L - 9
1. In View Call Plus application press the Monitor button while
the CO caller is leaving a message.
2. Press the Take Call button in View Call Plus to stop Live
Monitoring and connect with the caller.
- OR -
Wait until the caller has finished leaving a message.
SERVICE
CONDITIONS
Data Assignment:
Use Memory Block 1-8-08 [Class of Service (Station) Feature
Selection 2] Page 5 LK6 to Allow (LED On) or Deny (default: LED Off)
this feature.
Use Memory Block 7-1 (Card Interface Slot Assignment) to specify
the VMS/FMS (2)/(4)/(8)-U10 ETU or EliteMail CTI (4)/(8)/(12)/(16)-
U10.
A Feature Access key must be available to assign to Live Monitoring.
Feature code for Live Monitoring is 07.
The EliteMail VMS/FMS must have Live Monitoring set per mailbox
for one of the following:
• Manual Mode
• Automatic Mode
• Not Available (Default)
Restrictions:
Live Monitoring is not available for internal calls but is available for
the following outside calls:
• Calls forwarded to Voice Mail
• Calls transferred to Voice Mail
• DIT/DID calls to Voice Mail
Manual Mode is available only on terminals with softkeys.
To start manual Live Monitoring while the caller is leaving a
message:
To Next Page
Loading...