A - 54 Automatic Answer with Delay Message
Issue 6 Electra Elite
Use Memory Block 3-38 (Automated Attendant Message to Trunk
Selection) to assign the Automated Attendant message per CO/PBX
trunk.
Use Memory Block 7-1 (Card interface Slot Assignment) to specify
the VRS(4)-U10 ETU.
Restrictions:
Tie/DID lines are not supported by the Automatic Answer with Delay
Message feature.
DTMF digits cannot be dialed by the outside caller while in the
Automatic Answer with Delay Message mode.
CPUB( )-U10 ETU/MBD-U10 Unit PBR circuits are not used for this
feature.
Automatic Answer with Delay Message or Automated Attendant is
assigned per trunk.
Automatic Trunk-to-Trunk Transfer and Automated Attendant cannot
be set for the same trunk at the same time.
General:
The Automatic Answer with Delay Message feature uses the
Automated Attendant Message to play to the outside caller.
DIT/ANA assigned to the same trunk has higher priority.
Automated Attendant and system Access Codes can be assigned
individually.
Automated Attendant is assigned to tenants and follows the tenants
Day/Night/Weekend mode switching.
When Automated Attendant answer is assigned for a trunk and a
VRS(4)-U10 ETU is not installed, second dial tone is provided for
incoming callers.
RELATED FEATURES
LIST
Feature
Number
Feature Name
D-10 Direct Inward System Access (DISA)
To Next Page
Loading...