Nokia 7210 SAS-Mxp - Page 194

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
Platforms
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and
access-uplink mode)
Description
This command configures the uplink-B address.
The no form of this command sets the uplinkB to use DHCP to get the IP and the show bof value reflects
0 for this parameter.
Parameters
ip-address
Specifies the IP address of the BOF. This address must be unique within the subnet and
specified in dotted-decimal notation.
Values a.b.c.d
mask
Specifies the subnet mask length when the IP prefix is specified in CIDR notation. When
the IP prefix is specified in CIDR notation, a forward slash (/) separates the ip-address
from the mask parameter. The mask parameter indicates the number of bits used for the
network portion of the IP address; the remainder of the IP address is used to determine the
host portion of the IP address.
Values 1 to 30
uplinkA-autoneg
Syntax
[no] uplinkA-autoneg
Context
bof
Platforms
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and
access-uplink mode)
Description
This command enables speed and duplex auto-negotiation on the uplinkA port in the running configuration
and the boot option file (BOF).
The no form of this command disables the auto-negotiate feature on this port.
Note:
The uplinkA-autoneg command is not valid for 10gig ports. Therefore, whenever the user
selects 10gig ports as uplinkA port, the uplinkA-autoneg command is defaulted to no uplinkA-
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
194
SPACER TEXT