Nokia 7210 SAS-Mxp - Page 196

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
uplinkA-duplex
Syntax
uplinkA-duplex {full | half}
Context
bof
Platforms
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and
access-uplink mode)
Description
This command configures the duplex mode of the uplinkA port when auto-negotiation is disabled in the
running configuration and the BOF.
It also allows for the configuration of the duplex mode of the Ethernet port. If the port is configured to auto-
negotiate, this parameter will be ignored.
Note:
The uplinkA-autoneg command is not valid for 10gig ports, therefore, whenever the user
selects 10gig ports as uplinkA-port, the uplinkA-autoneg command is defaulted to no uplinkA-
autoneg, speed as uplinkA-speed 10000, duplex as uplinkA-duplex full, as shown in the
following output sample.
#uplinkA Port Settings:
uplinkA-port 1/1/26
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 10000
uplinkA-address 0
uplinkA-vlan 0
Default
uplinkA-duplex full
Parameters
full
Keyword to set the link to full duplex mode.
half
Keyword to set the link to half duplex mode.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
196
SPACER TEXT