Nokia 7210 SAS-Mxp - Page 197

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
uplinkB-duplex
Syntax
uplinkB-duplex {full | half}
Context
bof
Platforms
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and
access-uplink mode)
Description
This command configures the duplex mode of the uplinkB port when auto-negotiation is disabled in the
running configuration and the BOF.
This configuration command allows for the configuration of the duplex mode of the Ethernet port. If the port
is configured to auto-negotiate, this parameter will be ignored.
Note:
The uplinkB-autoneg command is not valid for 10gig ports. Therefore, whenever the user
selects 10gig ports as uplinkB-port, the uplinkB-autoneg command defaults to no uplinkB-
autoneg, speed as uplinkB-speed 10000, duplex as uplinkB-duplex full, as shown in the
following output sample.
#uplinkB Port Settings:
uplinkB-port 1/1/26
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 10000
uplinkB-address 0
uplinkB-vlan 0
Default
uplinkB-duplex full
Parameters
full
Keyword to set the link to full duplex mode.
half
Keyword to set the link to half duplex mode.
uplinkA-port
Syntax
uplinkA-port port-id
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
197
SPACER TEXT