7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
This command applies only if the profile is set to ieee1588-2008 or g8265dot1-2010. It does not apply
when g8275dot1-2014 is configured. When the profile is set to g8275dot1-2014, the value is set to –4 (16
packets/s) and cannot be changed.
For multicast messages used on PTP Ethernet ports, this command configures the message interval used
for synchronization messages transmitted by the local node when the port is in the timeTransmitter state.
The no form of this command reverts the message interval to the default value.
Default
–6 (64 packets/s) for ieee1588-2008
–6 (64 packets/s) for g8265dot1-2010
–4 (16 packets/s) for g8275dot1-2014
Parameters
values
Specifies the message interval, in log form.
Values –6 to –3, where –6 = 64 packets/s, –5 = 32 packets/s, –4 = 16 packets/
s, –3 = 8 packets/s
network-type
Syntax
network-type {sdh | sonet}
Context
config>system>ptp
Platforms
7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx 1/10GE (standalone), 7210 SAS-T (network
and access-uplink)
Description
This command configures the codeset used to encode the QL values into PTP clockClass values when the
profile is configured for G.8265.1. The codeset is defined in G.8265.1, Table 1.
This configuration only applies to the range of values observed in the clockClass values transmitted out
of the node in Announce messages. The 7210 SAS supports the reception of any valid value in G.8265.1,
Table 1.
This command applies only if the PTP profile is set to g8265dot1-2010.
Default
network-type sdh
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
396
SPACER TEXT
To Next Page
Loading...