7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Note:
The 7210 SAS-Sx 10/100GE 64SFP+ 4QSFP28 supports only the G.8275.1 profile.
The profile cannot be changed unless PTP is shut down.
When the profile is changed, the domain is changed to the default value for the new profile. On some
7210 SAS platforms, a profile change requires a node reboot. See Configuration guidelines and restrictions
for PTP for more information.
Descriptions in the config>system>ptp context indicate whether the command is applicable based on the
configured profile.
Default
profile g826dot1-2010
Parameters
g8265dot1-2010
Keyword to conform to the ITU-T G.8265.1 specification.
ieee1588-2008
Keyword to conform to the 2008 version of the IEEE 1588 standard.
g8275dot1-2014
Keyword to conform to the ITU-T G.8275.1 specification.
6.20.2.1.6 Date and time commands
set-time
Syntax
set-time [date] [time]
Context
admin
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command sets the local system time.
The time entered should be accurate for the time zone configured for the system. The system will convert
the local time to UTC before saving to the system clock which is always set to UTC. This command does
not take into account any daylight saving offset if defined.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
403
SPACER TEXT
To Next Page
Loading...