Nokia 7210 SAS-Mxp - Page 415

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command configures the type of schedule to run, including one-time only (oneshot), periodic or
calendar-based runs. All runs are determined by month, day of month or weekday, hour, minute and
interval (seconds).
The no form of this command removes the context from the configuration.
Parameters
schedule-name
Specifies the name of the schedule.
owner schedule-owner
Specifies the owner name of the schedule.
count
Syntax
count number
Context
config>system>cron>sched
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command configures the total number of times a CRON interval schedule is run. For example, if the
interval is set to 600 and the count is set to 4, the schedule runs 4 times at 600 second intervals.
Parameters
number
Specifies the number of times the schedule is run.
Values 1 to 65535
Default 65535
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
415
SPACER TEXT