7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
day-of-month
Syntax
day-of-month {day-number [..day-number] all}
[no] day-of-month
Context
config>system>cron>sched
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command specifies which days of the month that the schedule will occur. Multiple days of the month
can be specified. When multiple days are configured, each of them will cause the schedule to trigger. If a
day-of-month is configured without configuring the month, weekday, hour and minute commands, the
event will not execute.
Using the weekday command as well as the day-of-month command will cause the script to run twice.
For example, consider that ‟today” is Monday January 1. If ‟Tuesday January 5” is configured, the script
will run on Tuesday (tomorrow) as well as January 5 (Friday).
See the month, weekday, hour, and minute commands for more information.
The no form of this command removes the specified day-of-month from the list.
Parameters
day-number
Specifies the day. The positive integers specify the day of the month counting from the first
of the month. The negative integers specify the day of the month counting from the last day
of the month. For example, configuring day-of-month -5, 5 in a month that has 31 days will
specify the schedule to occur on the 27th and 5th of that month.
Integer values must map to a valid day for the month in question. For example, February
30 is not a valid date.
Values 1 to 31, -31 to -1 (maximum 62 day-numbers)
all
Specifies all days of the month.
end-time
Syntax
end-time [date | day-name] time
[no] end-time
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
416
SPACER TEXT
To Next Page
Loading...