Nokia 7210 SAS-Mxp - Page 419

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Context
config>system>cron>sched
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command specifies the minute to schedule a command. Multiple minutes of the hour can be specified.
When multiple minutes are configured, each of them will cause the schedule to occur. If a minute is
configured, but no hour or day is configured, the event will not execute. If a minute is configured without
configuring the month, weekday, day-of-month and hour commands, the event will not execute.
See the month, weekday, day-of-month, and hour commands for more information.
The no form of this command removes the specified minute from the configuration.
Parameters
minute-number
Specifies the minute to schedule a command.
Values 0 to 59 (maximum 60 minute-numbers)
all
Specifies all minutes.
month
Syntax
month {month-number [..month-number] | month-name [..month-name] | all}
no month
Context
config>system>cron>sched
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command specifies the month when the event should be executed. Multiple months can be specified.
When multiple months are configured, each of them will cause the schedule to trigger. If a month is
configured without configuring the weekday, day-of-month, hour, and minute commands, the event will
not execute.
See the weekday, day-of-month, hour and minute commands for more information.
The no form of this command removes the specified month from the configuration.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
419
SPACER TEXT