Nokia 7210 SAS-Mxp - Page 418

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
or weekday must also be specified. All days of the month or weekdays can be specified. If an hour is
configured without configuring the month, weekday, day-of-month and minute commands, the event will
not execute. See the month, weekday, day-of-month, and minute commands for more information.
The no form of this command removes the specified hour from the configuration.
Parameters
hour-number
Specifies the hour to schedule a command.
Values 0 to 23 (maximum 24 hour-numbers)
all
Specifies all hours.
interval
Syntax
interval seconds
[no] interval
Context
config>system>cron>sched
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command specifies the interval between runs of an event.
Parameters
seconds
Specifies the interval, in seconds, between runs of an event.
Values 30 to 4,294,967,295
minute
Syntax
minute {minute-number [..minute-number]| all}
[no] minute
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
418
SPACER TEXT